Engine oil level Reduce oil level!

发动机油液位过高！

Check the gear oil level.

注意齿轮油油位。

The required oil level in the tank has to be checked.

必须检查油箱中的油位是否符合要求。

If equipped with an oil level sensor, disconnect the sensor.

如果配备有油面感知器，断开感知器。

Start measuring the oil level by pressing the operating lever .

通过按压操纵杆可开始测量机油油位。

Inspect bearing lubrication if the oil level is in normal level.

检查轴承是否有油，滑动轴承应检查是否达到规定油位。

This same switch will also operate on low oil level, such as a slow oil leak.

其他低油位情况发生，比如慢漏油时，浮控开关也会有动作。

Check the oil level and top up with the required amount of oil (see above).

检查油位和补足所需的石油量(见上文)。

Check the oil level on the dipstick, making sure the level is in the proper range.

查看量油机，确保油压在一个合理的范围。

The inspection glass for oil level of main generator engine governor, to be renewed.

主发电机调速器用于检查油等级的检查玻璃需要换新。

Oil level marks in the housing and an oil level gauge help to keep the correct oil level.

轴承座内的油位标记和油位表使油位保持在正确水平。

Product Description :reliable sealing of head configuration , beautiful shape, clear oil level instructions.

套管头部密封可靠，外形美观，油位指示清晰。

For the oil level gauge, observation hole and the best use of natural materials, glass or polyamide materials.

用于油位计、观察孔等的材料，好使用天然玻璃或聚酰胺材料。

Hold hydraulic unit horizontally and check hydraulic oil level at the reservoir using the cross hairs marking.

扶住液压单元，使其保持水平，然后用十字线标记检查贮液罐中的液压机油油位。

Before switching on the power, inspect if the liquid and oil level are filled to the normal level as required;

在通电前应检查液位和油位是否按要求加注至正常位置；

Oil volume auto-measuring monitor is a fully automatic instrument of measuring oil level of automotive vehicles.

机油容量自动测量仪是一款全自动测量机动车机油油位的装置。

Anything else, please check the oil level since often a car, should as soon as possible to make up for the lack of.

别的，请常常查看自个爱车的机油油位，不足时应尽快弥补。

Changes of the oil level will directly display on the dashboard through the device, and as a result, safety is ensured.

机油的液位变化通过该装置直接显示在仪表盘上，确保了行车安全。

Check the tire pressure, oil level, and lighting of headlights, brake lights, and turn signals before starting the engine.

检查轮胎压力，石油级、照明头灯、制动灯、信号转开始前发动机。

Notice: Avoid overfilling, or the engine could be damaged. Check the oil level on the dipstick once again after adding the oil.

注意：避免过量填充，否则发动机可能发生故障。在加入机油后，应再次检查油平面。

Return oil is equally divided, and uniform crankcase pressure and oil level are purposely kept in equilibration parallel system.

油气平衡式并联技术平均分配回油，并强调气压和油位的平衡。

Finally, the oil level is obtained by normalizing the area of the oil part and the oil-free part within the ellipse into the circle shape.

最后计算椭圆中有油与无油部分的面积，将面积归算至油枕端面圆形中得到最终的油位值。

Flammable gas found in the relay indicates some internal fault such as overheating or arcing, whereas air found in the relay may only indicate low oil level or a leak.

如果在继电器中发现可燃气体，这说明有内部故障，比如过热或者电弧作用；而继电器内的空气只说明油位低或者有漏油。

Commonly inside the tank should be kept about 85% of the oil level, should be insufficient supply, add oil and the original of the oil pump should be the same number.

油箱内一般应保持85%左右的油位，不足时应及时补充，补充的油应与原泵中的油号相同。

On a slow accumulation of gas, due perhaps to slight overload, gas produced by decomposition of insulating oil accumulates in the top of the relay and forces the oil level down.

在气体慢积累模式中，可能由于轻微过在，绝缘油分解产生的气体在继电器的顶部聚集，迫使油位下降。

Aiming at the problems that dip sticks are easy to bend and low oil level can't be mea - sured, the writer puts forward two measures improving the structure of dip sticks.

针对量油尺容易弯曲和不能测量低液位的问题，提出改进量油尺结构的两项措施。