Shear viscosity increases as the shear rate.

剪切粘度随着剪切速率的增大而减小。

The shear viscosity decreases with increasing shear rate.

一定剪切速率下，剪切粘度增大。

The higher shear rate, the earlier reduction of strength of gel.

剪切速率愈大，发生冻胶强度下降的时间愈早。

The effect of shear rate on shear stress is included in the revised model.

修正后的计算模型考虑了土壤受剪速度对其剪切应力的影响。

The apparent viscosity at the point decreases distinctly with shear rate increasing.

随着剪切速率的增加，转相点的视粘度明显下降。

The apparent viscosity at the point decreases distinctly with the increment of shear rate.

随着剪切速率的增加，转相点的视粘度明显下降。

At lower shear rate, the fluid viscosity of composite has more sensitiveness to temperature.

在较低的剪切速率下，复合材料流体粘度对温度更敏感。

The influence of temperature, pressure and shear rate on formation damage are also discussed.

讨论了温度、压力、速度梯度对保护储效果的影响。

The related degree is high between blood viscosity in low shear rate and erythrooocyte aggregation index.

分组检验血沉定量增加时其余聚集指标和低切粘度的差异性。

Finally, the influence of shear rate and the number density and aspect ratio of the fibers are discussed.

最后讨论了纤维的浓度和长径比等因素对悬浮流微观和宏观性质的影响。

These included leukocyte rolling number, adhesion number, mean velocity of blood flow and venular shear rate.

观察指标包括白细胞滚动数、粘附数、平均血流速度和壁切率。

The complex viscosity decreased with the increase of shear rate in the form of approximate power law function.

动态复合粘度则随着剪切速率的增加而呈近似幂律函数形式减小。

The characteristics of shear rate in an airlift nitrifying bioreactor and its influencing factors were studied.

研究了气升式硝化反应器的剪切特性及其影响因素。

The viscometer was composed of mechanical rotating parts creating different shear rate, a sample cup and a cone plank.

设计的锥板粘度计由产生不同切变率的机械传动装置、放置血样的试样杯和锥板等装置组成。

By contrast, the viscosity of a melt of a plastic at a constant temperature changes markedly as the shear rate changes.

与之对比的是，塑料熔体在一定温度下粘度随着剪切速率的变化而变化。

The solution of SDF from soybean dregs were pseudoplastic fluid which viscosity decreased with the increasing of shear rate.

豆渣水溶性膳食纤维溶液粘度随剪切速率的增加而降低，呈现假塑性流体。

Melt pumping characteristics, velocity and shear rate distribution profiles of the screw assemblies are analyzed and discussed.

分析并比较了组合螺杆的熔体输送特性、速度场和剪切速率场分布规律。

There is little if any flow, shear rate is extremely low, and viscosity is off the top of the graph, perhaps something like taffy.

如果任何流动速度和剪切速率都很低（廖注：似乎为“高”），那么粘度就就很小，粘度就从曲线的顶部掉下来，或许像太妃糖什么的。

Transverse amplitude increases when shear rate falls into the lock-in range and decreases sharply when shear rate is out of lock-in range.

在剪切率的锁定区间内，横向振幅增大，脱离剪切率锁定区问后，横向振幅迅速下降。

The platelet adhesion on surface of fibrillar collagen under high shear rate condition was observed by parallel plate flow chamber with McAb.

利用平行板流动小室技术研究在高剪切力条件下该单抗对血小板在胶原表面黏附的抑制效果。

Laboratory simulating studies are made on shear rate of pipe flow for purpose of realizing long distance transportation of additive crude oil.

为了使加降凝剂的原油实现长距离的管输，就管流剪切速率进行了实验室模拟研究。

Methods: The distribution of 572 arterial plaques in 180 patients were analysed statistically, and arterial shear rate was calculated as well.

方法：对180例患者，572个动脉粥样硬化斑块的分布情况进行统计分析，观测血流剪切率与剪切应力。

The average shear rate obtained with this method is a more reasonable measurement of the average shear history of fluid in turbulent pipe flow.

对于湍流，按本方法计算的平均剪切率能合理地度量流体的平均剪切历史。

The optimal time which produces the best rheological properties of modified asphalt depends on the blend composition and on the shear rate used.

在生产改良沥青中，最佳的流变性能的最佳时间取决于混合物的组成和剪切率使用。

According to the definition, a relationship between the shear rate and the energy dissipation rate is obtained for turbulent flow of power law fluid.

根据剪切率和能量耗散率的定义，建立了幂律流体湍流剪切率与能量耗散率的关系式。

As the shear rate rises, the amplitude of pressure oscillation reduces, whereas the slide velocity, critical slide length and the frequency increase.

随剪切速率的增加，压力振荡的振幅减小，而滑移速率、临界外推滑移长度及振荡频率均有提高。

The pigment in this state exists as a pseudo-plastic fluid, whose viscosity, shear rate and solid contents can be related through a functional expression.

处于最佳分散状态的白色颜料分散液是一种假塑性流体，分散液粘度和剪切速率及分散液固含量三者关系可用函数式表达。