Mass is independent of the ambient condition in which the measurement is made.

质量与进行测量的四周环境状态无关。

Supramolecular hydrogels were formed via cooling the aqueous solutions of G2 under ambient condition.

通过在室温下冷却g2的水溶液，形成了超分子水凝胶。

The crystal structures, lattice energies and electronic band structures at ambient condition are summarized.

概述了常压下分子晶体的晶体结构、晶格能、电子键结构等晶体性质。

The effects of spray water rate and ambient condition on thermal performance of the cooling tower are analyzed.

分析了淋水密度、进塔水温和环境条件对冷却塔热力特性的影响。

Thereby, can get to improvement city ambient condition effectively , improve people the quality of life purpose.

从而，可以有效地到达改善城市环境条件，提高人们生活质量的的目的。

The phenology is the science studying mutual concern among plant, animal and the periodic change of ambient condition.

物候学是研究自然界的植物、动物与环境条件的周期变化之间相互关系的科学。

The results show that the hydrogen bond of supercritical water near critical region is only 29% of that of ambient condition.

研究结果显示在临界点附近水的氢键结构受到很大的破坏，只有相当于常温下29%左右的氢键存在。

When the magnetite suspension solution was used as catalyst, crystalline bamboo-structured CNTs were obtained. Y junction CNTs were also obtained under ambient condition.

当使用磁铁矿悬浮液作为催化剂时，得到结晶性良好之竹节状奈米碳管。而在适当条件下，可得到Y接点奈米碳管。

It was discussed in details that the model by difference method, the treatment of the ambient condition and the calculation of well flow model being coupled with reservoir.

本文详细讨论了模型的差分求解、边界条件的处理方法和井底井筒流体与储层流体耦合的计算。

Hot cracks refer to the liquid condition, whereas cold cracks are generated in the solid condition, generally at ambient temperature.

热开裂指在液态下产生裂缝，而冷开裂是在固态条件下，一般在环境温度下形成的裂纹。

Cold cracks are generated in the solid condition, generally at ambient temperature.

冷开裂是在固态条件下、一般在环境温度下形成。

Ambient environmental conditions can be reported and logged using the tri condition PST-THD.

周围的环境条件，可使用三重状况PST - THD进行报告和记录。

The influence of the orientation and condition on the ambient temperature tensile properties and the bending duc-tile-to-brittle transition temperature of P/M TZM sheet are also discussed.

试样的方向及状态对板材的室温抗拉性能及弯曲塑-脆转变温度的影响也在本文中进行了讨论。

Purpose is to enable the ambient temperature in a moderate condition.

目的是使环境温度在一个适中的条件下。